BB
I use alignment lines that I put on each side of the desing sections. But
if you have embird why not just reduce the design. You only have to go down
to 92% so that it fits in your hoop.
http://embird.com/sw/embird/tutorial/savsepr/savsepr.htm
This is a link to a tutorials on embird.
Good luck
"B.B." <none@none.com> wrote in message
news:on5077dd47jh30dj108onuudiu6ps9incs@4ax.com...
>I have Embird that I could use to split with. I'd like to stitch it out
> big, so any suggestions on how to get it all lined back up properly? What
> method do you use to do multiple hoopings so you don't have anything out
> of
> alignment? I've never had anything that big before to stitch out.
>
> On Tue, 13 Sep 2011 21:57:43 -0400, "ajsgramie" <noone@anytownusa.com>
> wrote in:
> <XRTbq.29324$zx2.26586@newsfe08.iad>:
>
>>I looked at the design and it looks like an easy enough split. I would say
>>split a where the brown meets the red weeper. Looks like you'd only have
>>to
>>split off a bit of the red. You will need some kind of software to split
>>it
>>with. You could just reduce it to fit the size of your hoop. Doesn't
>>look
>>like you have to reduce too much. I don't have the design or I'd try to
>>split it for you.
>>
>>"B.B." <none@none.com> wrote in message
>>news:a8rv67h6uim3bg13jqh6eet497aup5jsba@4ax.com...
>>>I am looking for some advice on splitting a large design. Is there
>>>anyone
>>> who has experience with this? I am interested in purchasing the Grim
>>> Reaper Full Back (#1569) design from Embroidery Library, but my hoop
>>> will
>>> only accommodate an 8x12 inch design. This design is 10.27"(w) x
>>> 12.57"(h). I don't have any experience with splitting, so I can't tell
>>> by
>>> looking at the picture on their site whether this particular design is
>>> possible. My biggest concern is actually stitching it out so that I get
>>> it
>>> all aligned properly. Anyone willing to share their expertise on the
>>> matter? I appreciate your time.
>>> Thanks,
>>> B.B.
>>>
>>
>
>
|
|